Opticsens (Pty) Ltd
Perimeter Intrusion Security Sensor Systems.
Contact OpticsensOpticsens ProfileOpticsens Home Whant To Be Our Agent? Page Language In: Arabic French Portuguese Spanish Chinese
Opticsens Home
  Contact Us
  Perimeter Security
    Perimeter Sensor
    Photo-Electric Perimeter   Sensor
    Wire Fence Security
    Palisade Fence Security
    Base Station Security
    Vehicle Access   Inspection Security
  CCTV Products
    CCTV Security Cameras
    Camera Lenses
    Camera Brackets

Opticsens Perimeter Security Sensors.

The Opticsens perimeter sensor is an eight zone sensor that can be used for optical or electrical vibration distributed sensing. The zones operate independent from each other and sensitivity levels can be optimized for specific detection elements. The optical fiber perimeter sensor can reach up to 6.4 km zone length wile the distributed electrical vibration perimeter sensor a length of only 100m.

Perimeter board

Perimeter Security Sensor Specifications:
Optical Sensor
Electrical Sensor
Sensor Cable
SM/MM Optical Fiber
3-core electrical
Input Voltages
300mA (4 zones)
Zone length dependent
Temperature Range
-20 to +70°C
-20 to +70°C
Zone Length (Max)
SM Fiber: 4.2 Km
MM Fiber(50/125): 6.4 Km
MM Fiber(62.5/125): 5.3 Km

Perimeter Security Sensor Communication Specifications.

The Perimeter security serial data acquisition interface allows control of 8 digital I/O lines and 8, 12-bit analog inputs, two analog outputs and one event counter via an RS232 or RS485 link.
The security data acquisition interfaces are daisy chainable up to ten units (80 zones with length 0 to 6.4km). All boards contain RS232 to RS485 converters.

A/D card

Perimeter Security Communication Specifications:
Supply Voltage
5VDC or 9 - 15VDC
Supply Current ( Outputs unloaded )
40mA Typical 60mA Max
Operating Temperature
-20 to +70°C
Analog Outputs (2)
Output Current
0-5mA total of both outputs
Digital I/O (8 TTL)
Sink Current
Source Current
Optical Communications
Wide temperature ranges (-40 to 80°C)
Signal up to 2.5 miles
10-30 VDC operation
2-way isolation
2000V input/output
CE approved

Perimeter Security Sensor Accessories Specifications.

The Perimeter intrusion security accessories include a GSM and Pager system control for alarm delivery.

Perimeter Security Accessories Specifications:
GSM Modem:
Integrated Quad Band EDGE/GPRS/GSM
Data, SMS & Fax operation
GPRS class 12
EDGE class 10
Integrated USB-Hub
Audio/Video streaming
Pager System:
UHF frequency (420 470 MHz)
Synthesized frequency and modulation
Requires 1 DB-9 serial port
Operates on 110V or 220V
Operating frequency: 420-470 MHz
Up to 1 mile range
   © Opticsens(Pty)Ltd. All rights reserved.  |   Legal Notices and Privacy Policy